Jig-zp8-210d | Manual [hot]

: Always wear eye protection, a dust mask (especially when cutting MDF), and ear protection.

[Handle & Trigger Switch] -------- (Speed Adjustment Lever) | [Upper Blade Guard] | ---> (210mm Carbide Saw Blade) [Lower Retractable Guard] | [Slide Rails] ======= [Back Fence Guide] | | [Miter Table] ------ [Work Clamps] | [Miter Locking Handle] Unboxing & Assembly Steps Jig-zp8-210d Manual

| Operation / Feature | Description | Key Action | | :--- | :--- | :--- | | | Secures the saw arm in a lowered position for safe transport. | 1. Push the saw arm down to its lowest point. 2. Push in the locking pin located on the back of the arm. | | Changing the Blade | For when the blade becomes dull or needs to be swapped for a different type. | 1. Unplug the tool. 2. Press the spindle lock button to prevent the blade from turning. 3. Use the supplied wrench to loosen the arbor bolt. | | Dust Extraction | Keeps your workspace cleaner and reduces airborne dust. | Attach the included dust bag to the dust port behind the blade. For even better results, connect a 35mm dust extractor or a vacuum hose . | | Repetitive Cuts (Cutting Multiple Pieces the Same Length) | An essential technique for efficiency on any project. | Use the material clamp to hold the piece securely to the left of the blade. Then, use a stop block clamped to your workbench to the right of the saw to set the cut length for every piece. | : Always wear eye protection, a dust mask

Pull the spring-loaded (located near the rear pivot hinge) outward. Push the saw arm down to its lowest point

Thread the miter locking knob into the front extension arm of the base turntable. Tighten clockwise to lock your desired angle.