: Always verify the "Machine" coordinate display after any change to ensure it matches the actual physical location. : Always perform a full parameter backup to a formatted CF card or external drive before editing. en.industryarena.com (APC zero return) using this parameter? How to Enable Parameter Write Enable (PWE) on a Fanuc CNC
For rotary tables (4th/5th axes), set 1860 in degrees per minute. A typical range: 1000–3000 deg/min. Because rotary inertia is lower than linear axes (usually), higher 1860 is acceptable, but watch for mechanical lash. fanuc parameter 1860
For standard setups where the encoder/scale properly transmits both position and speed data, allowing automatic updates. : Always verify the "Machine" coordinate display after
: Set to 1 if an absolute position detector is installed. How to Enable Parameter Write Enable (PWE) on
Note: If you replace the battery while the CNC is powered , you will keep your position data. If you replace it while the CNC is OFF , you will lose the position data, forcing you to re-calibrate using parameters 1860 and 1815. 3. Alarm 309 (APC Alarm: DVD Turn)